Search results

  1. O

    Need help with tfi upgrade and nutter bypass

    I finely finished replacing my dura spark module with a gm ignition module , i used accels performance module. I was going over a wiring diagram that I got when I did the TFI upgrade and I noticed that the + side of the coil was replaced with a 10 gauge wire. So I fugered it could'nt hurt to...
  2. O

    Need help with tfi upgrade and nutter bypass

    At this point I realize the ignition module is going out, so i''ve decided to replace it with a gm 4 pin module from summit ( proform, proformence control mod.http://www.summittruck.com/parts/PRO-66944C/.) Ive read all about how to do the install ,but my question is? will the gm module work for...
  3. O

    Need help with tfi upgrade and nutter bypass

    I'm still having stalls, so I'm looking into a ballast resister. I did locate and check the resistance wire and it was fine,no burn marks or broken connections. I did notice the writing on the line saying do not cut. Do i need to remove the resistance line and replace it with a ballast resistor...
  4. O

    help! no brakes

    I was going to start by replacing the master cylinder, but i decided to check the rear cylinders to see if they were leaking . When i pulled the passengers side drum the rear brakes fell right out. the adjustment parts were all disconnected . I'm going to rebuild the entire rear brakes and try...
  5. O

    help! no brakes

    I recently did a 4 in. lift and replaced the stock front brake lines with rough country lines, I rebleed the brakes and they worked great for about 50 miles. I was driving down the road when the petal went to the floor . no brakes. I went home rebleed again but no luck, I also checked for leakes...
  6. O

    Need help with tfi upgrade and nutter bypass

    I upgraded with the "juice box" coil, the instructions didn't call for reusing this part but I recently added a wire from the + side of the coil to a part called a ignition capacitor( i included a pic) and reconnected it to the old coil bracket . so far I've had no stalls, but i have herd of the...
  7. O

    Need help with tfi upgrade and nutter bypass

    I updated my jeep with a new motercraft carb, did the nutter bypass and upgraded to a Tfi coil (plugs,wires,cap,roter) . The jeep runs great but i'm having an intermittent problem. The engine will just die at times . The power to the coil is interupted and just cuts out. I have not replaced the...
Back
Top