Search results

What about a speedo gear for a 79CJ5,,, where can I locate the one i need for that?????

I have a 82 CJ 5, with a 6 in it,, I have 31" tires and 4.88 gears. My cluster says I am going 75, but my onboard gps says 52. So alot will depend on "your formula".

I need to have a new starter ring put on my flywheel. The teeth are nibbled off enough to need to be replaced.. My question is,, in shopping for a new one, a new ring is like $18 a new flywheel is like $142,,, but both together allready assemled is like $200... Is it that hard to put the starter...

Axle donar for cj5 I knew a guy that took the power steering "stuff" out of a,, I think wagonner.. and convereted his Cj to power steering,, Does anyone know the types of vehicles, year make, and what all would be needed to convert from, oh my hurts steering to power steering in a 82 CJ 5...

I have seen and heard of people getting wider and stronger front and rear axles from donar vehicles,,, which donar vehicles have the least amount of "conversion" and work the best for a 82 cj5???? Some have said with a dana 44 you have to use TJ springs????

lockers for $500?

oh,, its a '82 cj 5 with the engine and transmission of a '79

Here is as short as I can give it on my Jeep.. I have lifted it 4", weber carb, radiator, steering box, 4.88 front and rear, all new wiring, 31" tires, TFI upgrade, all new knobs and dash switches, new clutch, new starter, new bellhousing, high lift jack, new fuel pump, new water pump, gps, new...

What about a donor fan for a '79 6cycl CJ-5?? Any ideas?

If you had $500 to put into your Jeep,, what would you do... ????

believe its called a drive yoke return spring

I have taken my starter apart to put a new starter gear in it.. I have taken some things apart that i should not of but i have gotten them back together.. my issue is, i have about a 2 to 3 inch black spring left, and i do not know where it goes,, i presume near or on the starter gear but...

Minimum amount of bodylift for a belly up? Recently my Jeep failed to start!! The starter buzzed like bees, but no contact.. I took the starter off and the the outedge of the starter gear teeth were rubbed down.. I looked into the belly of the jeep and the starter ring, flywheel, also was...

Sounds like you will have to replace the whole thing,, the pipes are not real long and probaly have worked loose from where they connect to the coils

M.O.R.E. ? do you have the web link or web address?

jeep is a '79 6cycl. I am not completley sure on the carb,, lika 34-36 or something like that...

I have a Weber Carb that I have installed, and not sure if I have have all lines ran correctly.. Does anyone know where to find online pictures of how the lines are supposed to be ran???Thanks for any help..

Re: Getting to know your peers The pressure at idle is the same as traveling,, once it heads down,,, it only takes about 5 miles or so for it to head from 60 to 10 or lower. I am going to change the oil weight in it this weekend,, but sounds like by pump maybe bad?

I have the same question but for a '79 cj-5 thanks thomas

Just seems the pressure dropping that much, and down to that little would mean an issue somewhere in there... But I am learning as I go.. Thomas