Search results

Did you make it or buy it? Ive always wanted one but never even seen one. I usually pull the choke a little to get a few rpms.

Im for s.o.a. also. Although the jeep I have now is s.u.a. I done a s.o.a. on my first cj, not really hard to do either. Get some front and rear spring pads, weld the fronts exactly above the stock ones, check by measuring pad to pad in front of the axle and behind. These must be exact in order...

It all depends on right foot! I know of a quadratrac jeep with a 30 front thats a spring over with 35's and has been since '94. Ive ran 33's on my jeep for a while(about 20 years) and the last 2 years the front has been welded, now I have 35's on it, no problems so far. Just watch the go pedal!

Yes, Id like to have a dual windshield like that. I think they work good also.

I know about the problems of using a scout axle. If I could find a 75 dana 44 rear I would probably swap out the scout rear and keep the stock front axle. But I would like to use the scout stuff because its wider and stronger that stock. I already have a 2.5" lift on my jeep and run 33's just...

I have a '78 cj7 with a 15 year old rancho 2.5" lift and 33" tires. It has a scout 44 rear and dana 30 front. I have the scout front but havent got to install it yet. I just bought a set of outlaw ll rims and 35" pro comp mt's. Should I swap the 2.5" lift for a 4", or keep the 2.5" and add a 2"...

I was gonna ask if you needed some help cause Im close by you, but youve already fixed it! Good deal!!

Stay safe over there!

Any idea what brand they are?

How much for the springs?

If your still interested I can meet you in ashville Nc. My dad lives there, it would save you about 3 hours of drive time.

If its the stock axle then its gonna be a model 20. Ive got an old lockrite locker that I give you if you buy my t-18. It needs a new spring kit.

What kind of rear axle do you have?

Where are you located? If you get the transmission you will love the granny gear.

I just saw your post on the swamper thread. Ive still got the t-18. I used it in my cj until I swapped it for the t-18/dana 300 combo that Im using now.

Im north of knoxville Tn. Which one are you interested in?

Good deal. Im trying to put a set of 44's out of a scout into my jeep. I kinda wish I had just got a cj 44.

What kind of 44 did you get?

Sounds like putting the 44 in will also help the driveshaft length.

No help to you but I cut one in half last year and scrapped it because know one wanted to buy it.