Search results

fyi: if you get rugged ridge mirror movers, cut the little overhang on the back end off, they will prevent you from sliding your door off. Dont even get me started about why someone would make a mirror moving bracket that you cant take your doors off with.

my .02 for your situation on the cheap Get a 2" BB for around $200 Used Rubi springs $50 for the set of 4 (no real "lift" but it will replace your old and sagging ones so you 2" lift is correct and on the cheap) 32's on your stock wheels (assuming the are the 8" wide alloys) and adjust your...

i wouldnt worry too much about that back corner inside the tub, you already know its F'd up. Id spend my time looking towards the front of the tub to really get an idea about how widespread the damage goes. There are internal panels that are attached to the tub from the inside that gives it...

miraculously the CEL was gone when i brought it to inspection yesterday and it passed, im checking the fuses this weekend when im in it for oil and spark plugs

Not only in the back but all over the jeep. The biggest indicators will be the inner structural plating by the B piller (around the floor mounts of the rollcage by the seats) and the area around where the drivers and passengers feet would be around the door jams. If it looks like these two...

rubicon springs are the same length as other TJ just much harder spring i.e. the lift that is perceved is due to the old springs being softer and sagging.

if you look along the lower edge of that rear window you can see it bowing a little, thats not impact damage, thats wrinkling. I wouldnt be suprised to see some sort of damage along that back side of the door where the striker is. Before you decide to buy it pull all the carpets out and look...

here is what mine looked like when i got it doesnt look that bad right, just a couple small dents? Wrong, not a single thing lined up.

from someone who has just recently put together a rolled jeep this is WAY more work then you think. You can try to pull and cover with corner armor but this damage is going to be spread through spots you dont expect. even though those doors close, it doesnt mean they are square, put another...

it doesnt have the mini cats on the header but i wasnt sure if that was only equipment for the CA emmissions jeeps since i dont remember mini cats on my 97 tj but i sold that a few years ago so i could be wrong. I wasnt sure so thats why i thought it might be an aftermarket header that...

pic

now the next one i can get the pics up, thanks for sticking with me :)

here is number 4 post

i tried to post pics but i need a few more posts

thanks for the help but in an odd twist i got under there yesterday to find that both upper o2 holes are plugged. There is another further down the header before the cat but i thought that was my down stream o2 sensor? I looked around for a good ten minutes and found no random plugs in the...

I actually just threw the P0141 code last night on my first drive after putting a rolled jeep back together. I figured it would just be the O2 since i know they are delicate but now i would like to check the fuses first. I checked my chiltons manual but i couldnt figure out what fuse is...