wire

  1. TerryMason

    What is this connector for under the seat of my TJ

    What am I looking at here? This connector goes to the driver's seat of my 2005 TJ. There is not one on the passenger seat. Wire coming out of the floor: Connector on the drivers seat:
  2. J

    tail lights suck

    So my passenger side rear running light isnt working. the assembly is fine, everything work fine when plugged into the other side. There is no power to the wire that powers that running light. can i splice into the power wire for the driver side to power the passenger side. Or do i have to run...
  3. C

    Brake Light switch supplemental braking

    Hello All I am trying to figure out what wire is what. I need to install a Road master Brake Pro 9300 Proportional Towed Car Brake Unit in to my 1993 Jeep Wrangler 2.5 5 speed I have attached the type of connector I need to tap into. This photo is the switch side, the plug/harness side has 5...
  4. S

    Another crank/no start. No spark to coil, new CPS... help!

    Hi all, first post on Jeepz! I wasn't having any luck on another forum so hoping for some help. I have a 1999 Jeep XJ and I have no spark from the coil. The coil is powered with the 12v wire, but the signal wire does nothing. I have checked the other end of the signal wire at the PCM side...
  5. aggreX

    KC Cyclone Underhood Light kit

    Installed a set of KC Cyclone 2-light Under Hood lights. Ran the wires through the hood reinforcement beams. KC lights come with everything you need: protective wire wrap, wire harness and switch. Made one change to the instructions by using rivet nutserts to bolt the lights onto the hood...
  6. J

    Start run lights problem

    If I turn on my lights the engine will die. Turn the lights off runs fine. Remove the park lights fuse and turn on head light and it runs fine. Replace the park light fuse engine dies? I have no clue where to go on this one.
Back
Top