installing one piece axles in amc 20

[c_herrman]

1072004

Hi guys, i'm in the process of installing one piece axles in my cj from Yukon....unfortunately the axles did'nt come with any instructions, or diagrams....and i want to make sure i get them in right.....anybody have some insight, or diagrams that may help? any help will be greatly appreciated......Thanks

Cory[addsig]

 

[far_right]

1072008

call yukon, and see if the directions were left out, but my chiltions man has instructions for that, so you might want to pick one of those up good luck[addsig]

 

[c_herrman]

1072032

btt[addsig]

 

[olyeller]

1072043

I've recently replaced an axle in my 84 cj. It's a pretty straight-forward operation.

1. Jack up and support the Jeep.
2. Remove the tire.
3. Remove the brake drum and all brake parts. You'll have to disconnect the brake line at this point.
4. Remove the brake backing plate and bearing/seal retainer.
5. Pull the axle out of the diff housing. A puller will be required for this.
6. Insert new axle and reverse the disassembly steps.

Don't forget to put in a new seal and bleed the brakes.

edited by: olyeller, Jun 18, 2003 - 05:53 PM[addsig]