Moser 1 piece amc 20

[james5454]

Just put in my trutrac and installed my moser 1 piece axles. They went in fine but after touring the backing plate bolts down they are a bit stiff to turn. Anyone else run into this? Is this normal since they are new and haven't been run? Will it loosen up a little after it gets. Few miles on them? It not so tight that I can't turn them by hand though. I can grab them and turn them all day.

 

[69jeepcj]

It has been a long time since I have installed a set, but if you have the end play set correctly then I would think it is fine. If I remember correctly the end play is all there is to set. Ran mine for almost ten years with no problems

 

[james5454]

The good thing about the moser is there is no endplay adjustment. Just once everything is in the tube the bearing is supposed to stick out 0.020"-0.080". I'm within that. Just stiff. Wondering if that goes away. But I'm with you if everything is in specs it should be ok. Sometimes I wonder though.

 

[69jeepcj]

I would be wondering too. Can you find a phone number for moser and call them? Its been so long I honestly cant remember if mine was stiffer or not after the install.

 

[james5454]

Yeah. It's on their instructions.