Search results

i gotta 96 grand cherokee 4.0 and im havin problems it keeps wantin too run hot if you start it and not drive it itll hit 210 and never gett any hotter and the thermostat dont feel like it ever opens but you can go drive it and itll run the 2nd and 3rd mark past 210 mark iv putt 2 water pump in...

Thank y'all for the advice

Went from 4mpg too between 8-10 when ya keep your foot outta it

Ok jw I did it too my 85 Chevy and noticed a big difference

Will it hurt anythang if I remove the front drive shaft in my 96 grand Cherokee for better mpg its gotta 4.0 auto trans and full time 4x4 transfer case

my 92 cherokee (stock 4.0) wont sstart all it does is clicks i have tried jumpin it and it will sometimes turn bout halfway over then just starts clickin it did this the other day and i wiggled the jumper cables aand it started but ran really rough for bout 30 sec then fine i went too start it...

Well guys I thank I gotter figured out I had it ggrounded into the factory harness but the wire had one of those male conector ends on it I cut it off and it aint doin it now

I got it wired positive to the fuse box and ground threw factory harness the antena never has been hooked up it was wrecked and they cut the wire off the fendwr and hooked speaker wire too the antena cable

Would that cause it to interfere with the cd player? and would not havin a proper antena hooked up do anythang?

It does change with rpm but I noticed the other day it does it without the motor runnin as well so im still lost

how do you go bout findin out if its a CAD or not?

so iv been thankin bout weldin my front axle its on a 92 cherokee stock fronnt axle too make it possi would this have an effect on daily drivin on the road? and would it hurt if i did the rear as welll?

my 92 cherokee has a hum of the engine noise in the radio what causes it and how do i gett it too go away

my 85 chevy pick up had flowmaster 40 on it when i bought it and its straight pipe off headers and you cant beat it my buddy had a 96 with thrush glass packs on it and it was pretty loud too

i haad one on my jeep for awhile it sounds pretty good i like the staight pipe sound tho if ya ask me

if the gasket aint broke and its still in one piece you should be able too putt the glass back into it use some soapy water and work it on the put it back in the frame start at the bottom and use a couple screw drivers i did this with my 85 chevy

iv just been replacin the bolts and straps not the yoke it seems too only be happenin when i gett on it too climb a hill ima need too replace the driveshaft last time it broke it beat it up ppretty bad were can you have one balanced? how would i check the pinion angle? if the pinion gear was...

i live in scott co right down the road from mccreary co we ride through capachine out too winfield bout a 5 hr ride

its got the 4.0 its got the stock auto trans and transfer its got a 3in lift iv been gettin em from the jy it just sarted happenin its done it 4 times

i have a 92 cherokee and its my first jeep i dont no a thang bout em. im havin a problem with the u joint it keeps breakin the bolts and the straps can anyone help??