Search results

Hey thanks for making me a Senior member.

I find myself wondering, What I did I do with my old sports cup? Mite have to become standard Wheeling-were! LOL.

I found that when I put it back on I did not have the 7" tension bolt seated in its correct position, my bad, noise gone, thanks.

I had to remove the tension pulley in 96 xj. Put it back together and in getting a weird noise, My question is the way its assembled #1 Bolt threw pulley, #2 then a really thick washer. Now is there another washer in there somewhere that may have fell without me seeing it? Or dose it just screw...

thanks for the input, I'm not only going for looks but functionality also. I know I don't want too much weight up there though so I would think I should use some sort of lite tubing and not iron? Don't have excess to welder so I have to use some sort of couplings to attach the tubes with bolts...

Welcome, Nice Jeep. A little too clean though. JK.

I would go with the ". Second option if VIN can't be replaced, exchange vehicle with pre accident replacement cost vehicle of similar type and condition." And get a good attorney and sue for emotional distress also. You did love your Jeep like a child I'm sure. Good luck.

You can get it in galvanized tubes that are made for outdoor use, or do you think this is to flimsy too. Ive seen them made with the top of a futon bunk bed and that cant be much stronger.

What do you think of using electrical conduit to fab a cargo rack?

looks like a new locker is in store.

chek it out,,Home Brew Budget Boost

Sorry wrong link.

Try some WD40 in the cylinder.

Jeep Horizons :: Cherokee (XJ) Stock Specifications

Living in the northeast there are jeeps everywhere. So when preforming the jeep wave at every jeep up here is futile. I do pass out jeep waves like i pass out out tic tics. There are jeeps that will wave most of those are pre 2000 or modified. This is a true keeper and not a soccer mom that...

Not for nothing but I had a loud rotating grind that had me thinking drive train. Got underneath and found that the ex oust shifted and was rubbing the gas tank, A few adjustments and no more grind. Noise under the jeep or any other car for that matter is hard to isolate so dint panic it could...

What I'm finding in the Haynes manual is that there are seals at the end of the tubes near the hub. And after 1990 they used c clips to hold the axle in. Before 1990 you just pull the axle no need to open diff. Looking at a schematic of the 35 it shows inner and outer seals but after looking at...

I just drilled two holes. But get the plastic inserts for the bolt because try to get in the back of the bumper is a p.i.t.a.. although it can b done.

I have grease built up on the drivers side drum breaks. Is this because of outer seal or inner seal? This is a Dana 35.