Body Lift Problem/Help!!!

[67bbc]

1066524

OK, Installing my body lift and got down to the last bolt (of course) and the bolt/threads are stripped...I could use your advise on removing it. Anyone run into a similiar problem? Pass. side mount just behind the front wheel. :-?
[addsig]

 

[Snitty]

1066535

an impact gun helps a lot or stubborn threads, but for stripped heads craftsman sells an inverse easy-out that works for stripped bolt heads.[addsig]

 

[mandarrin]

1066543

just use one of those pressure pryers.[addsig]

 

[Bounty__Hunter]

1066549

You're going to have to make a small cut somewhere in the tub to get a wrench on the nutsert inside the tub.[addsig]

 

[ajfrank43]

1066687

Crapsman, try SNAP ON. :-D [addsig]

 

[Beefy85CJ7]

1066693

if you were to cut a small access hole in your floor board, you'd be right where you wanna be. I remember my old tub was rotted out pretty bad and i could see the square nut plate right through the floor...plenty of access when it came time to remove it. just a thought. Good luck.[addsig]