control arm bushings

[lippy]

I got the front end figured out but my problem is something else. when I hit the gas you can feel the whole back of the jeep sway back and forth. like if you were hitting passing gear you feel the sway as if there was no track bar holding it straight. I think that might be the big problem. bushings in control arms???????? any other ideas???????????????

 

[LGR]

could be that or the trackbar in the rear...they got them in grand cherokees right?

 

[lippy]

brand new track bar with lift kit!!!!!!!

 

[LGR]

brand new track bar with lift kit!!!!!!!

how about its mounts? loose?

When Installed my lift I had a problem..the new mounting bracket wasn't tight enough and the old bolts would loosen up.

All this happen after your lift? or its been on for awhile

 

[bchcky]

how long since you installed the new parts? its always good to tighten your bolts now and then once you've installed for safety's sake.

 

[lippy]

been installed for about 2 weeks 250 miles

 

[Bounty__Hunter]

Did you install any new rear control arms with the kit? Sounds like a loose rear track bar and/or bad rear control arm bushings.

 

[lippy]

Im going to be replacing all control arms with adj on bottom and fixed on top. Front wheel hubs and ball joints. Im going to have it for a long time I might as well have all new and tight parts to put another 250000 miles on her.

 

[lippy]

anybody use or have seen in action the rustys long arm set up?????? im looking at that setup as opposed to getting the adj. short arms. Iv heard and read that is the way to go.

 

[Bounty__Hunter]

If you want longarm, go with the Y-link from www.tntcustoms.com/webV4/xjylinksystem.asp