Is this pinion as bad as I think it is?

[superj]

That looks like a slinger. Can you put it on a piece of wood and straighten it with a ball peen by tapping it out?

 

[JPNinPA]

Okay got the opinion out. It didn't take much effort for my impact to pull off that pinion nut.

To my untrained eye, the pinion gear itself looks good but the bearing and races looks cooked

Sent from my Pixel 7 using Tapatalk

Yep. Thats your pinion opinion.



Never look down on anyone unless you are helping them up - Jesse Jackson

 

[TerryMason]

Things were going good today for a while, I had my backlash dialed into 10,000s and everything looked good. I decided to run a pattern before I buttoned everything up. From what I gather this is a pretty bad pattern. I applied way too much of the paint but the drive side looks pretty bad.

I'm not sure if I need to change the backlash by removing carrier shims or if I need to change the pinion shim. I'm open to any ideas.

Sent from my Pixel 7 using Tapatalk

 

[TerryMason]

I'm trying to decide if it this scenario is the green or the blue.

I tried to shortcut things, and just went full send with a crush sleeve, locktite, etc. I assumed that since I was just changing the two pinion bearing and races I'd be fine. Now I need to pull it apart.

I'll try moving the carrier shims first, and if that doesn't change things the I'll pull the pinion gear out and change it's shims.

 

[superj]

I would say you got the blue outlined marks