1072299
I replaced the 2 u-joints on the rear drive shaft and reassenbled exactly the same way to ensure proper drive shaft balance, I used new straps and bolts and inspected the drive shaft and all looked fine to me. After re-assembly I still was getting the knocking noise so I rotated the shaft 180 degrees thinking it may have been incorrectly installed when I had the trans rebuilt, This only made the noise worse. The jeep is a 93yj 6 cylinder 5 speed manual trans. I'm out of ideas can anyone offer any advice? Thanks, Frank[addsig]
I replaced the 2 u-joints on the rear drive shaft and reassenbled exactly the same way to ensure proper drive shaft balance, I used new straps and bolts and inspected the drive shaft and all looked fine to me. After re-assembly I still was getting the knocking noise so I rotated the shaft 180 degrees thinking it may have been incorrectly installed when I had the trans rebuilt, This only made the noise worse. The jeep is a 93yj 6 cylinder 5 speed manual trans. I'm out of ideas can anyone offer any advice? Thanks, Frank[addsig]