Search results

I realize I'm a little late on this, but I've dug into a bunch of 242s. If you still need help, PM me

You'll be looking forever if you are trying to find away to get ride of code 12. Code 12 is also known as the "start of codes" code. Don't worry about it, it will always be there. As for the starting issue.... Take a pair of jumper cables; hook one end to the positive terminal and one to the...

The seal is a very easy thing to replace. Rip the old one out with whatever it takes to do so. I use a large screwdriver to stick in there an pry. Make sure the surface is clean before installing the new one. Most people say it takes patience but I've done so many, I've found that there are...

I have no cat and no muffler (got ripped off on the trail). I also have no backpressure. When I rebuild I have a 40 series to go on

Sooooooooooo.... Thomas Jefferson and Superman have what in common? The "and all that..." remark was most likely an internationally politically correct sugar coating so the movie helps sell internationally. Right now, there are many nations that may not be so happy with our country. Superman...

Haha.. you guys don't even want to see mine

NYC area

You said that you had the trouble only when the front brakes were installed... If you are sure that the master and rear half are solid, I would say to take the banjo fittings off the calipers and close them off with nuts and bolts. Have someone help you bleed each side so there is no air. This...

Where the heck is Ol'Man Tug? It's about time for him to run for president isn't it?

I am quite late chiming in on this here. I haven't been around too much lately... I am loving it very much and I'm very impressed. Great work

Yeah both blocks had the same bolt pattern for a bellhousing

The speedo sensor has to be clocked just right in order to read anything

I am strictly against putting an amp inside a sub box. There is a great risk of overheating. I have build amp boxes before, but they were not sitting next to and sharing air with a huge hot magnet. ANY box that is used to enclose an amp MUST be vented with cooling fans... TWO cooling fans...

(actual current tire size x wrong mpg) / actual stock tire size = correct mpg

I agree with rooster. Shackles and body lift are inexpensive. I've seen both done in drastic forms. Too much shackle lift, as already said, will cause instability and geometry problems. Body lifts, when too drastic, pose a problem with the shifter and steering shaft. They also put a lot of...

I have 33 inchers and still stock 3.07... I don't have any problems

How much for that Focus dual fan?

Booooooooooooo.... no 4.0... still a nice vehicle though. I wish they would make the diesel engine available to North America

I'm with saurian. A bad fuel mixture can cause catconv failure

Right.. any decent machine shop would be able to make something for you